Specification

The collated autofeed takes 25-50 mm collated screws and will take upto 55mm. The attachment is easy to operate using an Allan key to take on and off and set the gauge to length of screws being used, and a simple dial controls countersink management. The attachment can be set to feed from the top or sides and Concept do not require that the builder use our collated screws unlike other companies. Concept do however recommend that a quality strip is used so that the tool operates at optimum speed and there is less chance of jamming etc.

- 167 Nm power (approx 20-25% more than equivalent 14.4V Impact Drivers)
- 2,300 RPM no load speed
- 3,000 BPM impacts per minute
- Forward / Reverse action
- Electric Brake
- Variable Speed Control
- LED Lights
- Countersink control dial
- Quick and easy to fit and remove attachment
- Rubber end piece for paper protection x 2
- Belt track for stability
- Release button for easy removal of strips
- Autofeed positions screw before driving so less chance of jamming
- Attachment can be fitted to feed from top or side
- Weight approx 2.9 Kg